RI SM2018 Week04A

Student Presentation

Assignment 3.1 Render all

Render all previous models in Keyshot, and upload images on the website

3D Printing

biomimicry-shoe

http://www.dezeen.com/2012/07/17/biomimicry-shoe-by-marieka-ratsma-and-kostika-spaho/

Digital Native

http://www.dezeen.com/2012/10/12/digital-natives-by-matthew-plummer-fernandez/

Waratah 3D printed Lamp

http://blog.ponoko.com/2011/02/03/waratah-3d-printed-lamp/

Creating a Vase

Outside

  1. Create a bounding box @3x3x6″ with “box”  and “DupEdge”.
  2. On top view, create a small circle near the edge of the bounding box
  3. Run “ArrayPolar” command (20 / 360) to create array of the circles
  4. Use “CurveBoolean” command to extract the edges of the array
  5. Copy extracted edges to Z direction 3 times (4 total)
  6. “Record History” and “Loft”
  7. Adjust scales of the sections

Inside

  1. For each section, offset each curve at 0.1″
  2. Draw “circle” to each offset curves
  3. “Record History” and “Loft”
  4. Adjust locations – bottom needs to be 0.1″ higher
  5. “PlanarSrf” to create bottoms for both inside and outside
  6. “Loft” to close the top
  7. Join the whole model – Check “Properties” to see if the model is “ClosedPolysrf”

Blend Shape

EdgeSrf

 

Assignment 5.0 Flower Vase Design for 3d printing

Sketch and develop your own vase.  3D model and render on rhino.  Upload a few views

 

We will go over the process of submitting 3D prints.