Student Presentation
Assignment 3.1 Render all
Render all previous models in Keyshot, and upload images on the website
3D Printing
http://www.dezeen.com/2012/07/17/biomimicry-shoe-by-marieka-ratsma-and-kostika-spaho/
http://www.dezeen.com/2012/10/12/digital-natives-by-matthew-plummer-fernandez/
http://blog.ponoko.com/2011/02/03/waratah-3d-printed-lamp/
Creating a Vase
Outside
- Create a bounding box @3x3x6″ with “box” and “DupEdge”.
- On top view, create a small circle near the edge of the bounding box
- Run “ArrayPolar” command (20 / 360) to create array of the circles
- Use “CurveBoolean” command to extract the edges of the array
- Copy extracted edges to Z direction 3 times (4 total)
- “Record History” and “Loft”
- Adjust scales of the sections
Inside
- For each section, offset each curve at 0.1″
- Draw “circle” to each offset curves
- “Record History” and “Loft”
- Adjust locations – bottom needs to be 0.1″ higher
- “PlanarSrf” to create bottoms for both inside and outside
- “Loft” to close the top
- Join the whole model – Check “Properties” to see if the model is “ClosedPolysrf”
Blend Shape
EdgeSrf
Assignment 5.0 Flower Vase Design for 3d printing
Sketch and develop your own vase. 3D model and render on rhino. Upload a few views
We will go over the process of submitting 3D prints.